A place to ask questions about Altair products or solutions and receive help from community members or Altair employees. Don't forget to tag with the product/topic related to your question. Once you receive a satisfactory answer on your question, kindly mark your answers as "Accepted" so it can help others with similar problems.
Hello! I solicited and successfully activated my Altair student bundle and was already using both HyperMesh (2025) and Inspire (2025) without any issues. When attempting to use BatchMesher in HyperMesh 2025, however, the work status returns to "pending" providing no result. I'm fairly certain my student license is…
Hi, I’m getting the following license error when launching FlightStream: The Altair License Manager is running, and the license file is in the expected location. I also tried restarting the service, but the error still shows up. Does this mean the license doesn’t include the GlobalZoneAM feature, or is there something else…
Hi all I created a tablecontour with *tablecontour command in tcl. Is it possible to get the value list or properties of the contour. I could not get the id of contour. Even i dont know the name of the legend. When i look in api reference guide. There are some commands to change the colour like thickness_legend but it was…
Hello, I am trying to verify different sizes (infinity x infinity, 16 x infinity, 16 x 16) of the referenced Dual-Polarized Planar Ultrawideband Modular Antenna Array [1]. I have created a simplified parametric model of the Unit Cell (attached herewith) in FEKO. Instead of modeling the connectors and energizing using…
Hi, I am very new to EDEM. I recently purchased an Altair license and am trying to use EDEM to model and simulate nanoscale structures, particularly DNA double helix bundles. However, I’m facing significant difficulties in modeling such nanoscale structures within EDEM. My objective is to represent a DNA double helix…
Hello everyone, I'm currently facing this error, when I'm triing to run my simulation: INTERNAL PROGRAMMING ERROR # 8011 DELETE detects overwriting of data block: igwrk2. DATAMANAGER ERROR in subroutine "datamd". This model is just a test model to investigate the effect of changes in the setup. I have tried to use ‘GPAD’…
The thickness of the washer elements here were automatically assigned as 2.495. However for all other elements i have thickness values upto one decimal only. So here also i want it as 2.5. But if I use organize tool to change the collector to 2.5 thickness category, they are still staying the same and not getting changed.
I formatted my laptop because it did not work properly, so I cannot reactivate the Student Edition License on my new laptop. Please disable the license on my old computer so I can reactivate it.
Hello everyone, I need to simulate a model where laminate A is soldered to PCB board B, and PCB board B is glued to a structural component, then perform thermal stress (deformation) analysis on the entire system. Here are my specific questions: 1. Material Model Selection PCB board B and the structural component are…
Description: i am a student, new to motionview, and i want to simulate a gear rolling forward and at the same time moving forward. But these two motions are independent, like the gear on the bike when bike is moving, the rolling and moving are not related, they have different velocity. i tried to use a revolute joint and…
There's a wealth of content waiting for you to explore! Need support or have a question? Login or join our community.