I cannot proceed to analysis from Hypermesh2025. Please help me.
I am currently learning Hypermesh2025. When using the export function of Hypermesh to export a solver deck for Radioss or OptiStruct, no file is created. Could you advise me on how to resolve this issue?
Answers
-
hi,
You need to do File → Export→ Solver deck to export a file in Optistruct/Radioss.
Check that you are using correct solver interface with .fem as extension to file name when using Optistruct.
Thanks…
0 -
Hi
If there are special characters in the name of the solver deck you want to export, I suggest you fix them and try again.
0 -
Thank you for your response. Unfortunately, it did not resolve the issue. If there are other possibilities, I would appreciate it if you could share them.
0 -
Thank you for your response. Unfortunately, it did not resolve the issue. If there are other possibilities, I would appreciate it if you could share them.
0 -
Is there any message in the lower left hand corner of HyperMesh? If there is a problem to export, it would normally report it there, can you try exporting to a different folder location, in case it is permissions related?
0
Altair Employee