The most recent content from our members.
The Siemens Community Catalyst program was co-created with our community to acknowledge technology leaders who consistently contribute to the Siemens Community. Nominations are accepted on a rolling basis.
Hye Everybody, I've been struggling in NLGEOM analysis with error#4002, error#4079. I want try implicit contact with gap, and gap will not very close to another contact object. The gap will over the autoly gap calculation by optistruct from all of the PCONT,PCNTX7,IGAP methods. I use NLGEOM because i want to control the…
I have the following optimization case below, with four fixed supports at one end of the structure and a hole with a downwards force on the other end and design space in red, and as far as I can tell I've followed all the steps in the basic Altair tutorials correctly, but this case does not run on the default optimization…
this is 3 wheeler with (2F-1R) configuration .steering angle for double lane change test is as shown below even though im able to run double lane change test , i am not able to run Constant radius test which shows solver failed with the following error. can anyone help me figure out where i have gone wrong
Ansys Fluent用のメッシュデータに対して、モーフィング機能を適応させたいのですが、 一般的にはどのソフトが最適でしょうか？