warning quality mesh
Hello every one
when I run the OptiStruct in the .out file i found these warnings . can i cancel this option under OptiStruct ?
Element # 6, element type TETRA.
WARNING - Outside of recommended range: Face Skew Angle = 76.060
upper limit = 75.000
WARNING - Outside of recommended range: Face Vertex Angle = 7.4711
lower limit = 15.000
WARNING - Outside of recommended range: Edge Angle = 81.129
upper limit = 75.000
Find more posts tagged with
Sort by:
1 - 6 of
61


Updated by Altair Forum User
Hello,
but think about to correct your problem, don't ignore it...
Best Regards,
Mario

New Altair Community Member
Updated by Rahul Rajan_21763
to bypass element quality checks (except essential validity checks) , use PARAM,CHECKEL,NO
This is created in the control cards panel,
It is advised however that you improve the quality of your mesh, see element quality checks and fixing tips in the student guide and the training center here- http://training.alta...lement-quality/