Rapid miner studio tutorial error

ihor
ihor New Altair Community Member
edited November 5 in Community Q&A

Hello everyone, I just started using Rapidminer studio yesterday and decided to start with a tutorial.

Already on Get Started 2/8 Modelling i got an issue, that blocked me a lot: I followed all the instructions in the list and created a very simple model as was told and you can see in the picture:

1.jpgmodelThen when pressing run button there occurs an error of the following type:

 

 


2.jpgerror

Then after obvious move of connecting, the problem doesnt dissapear:

3.jpgstill error

Summarizing, I was just following all the details of the tutorial and got stuck with this.

I would be very grateful if somebody has a clue how to proceed with this and where was the error I made during the process.

Tagged:

Best Answer

  • Thomas_Ott
    Thomas_Ott New Altair Community Member
    Answer ✓

    @ihor you're using the wrong Decision Tree. The one you have pulled in is the Decision Treet Multiway, which requires another model producing operator inside. 

Answers

  • Thomas_Ott
    Thomas_Ott New Altair Community Member
    Answer ✓

    @ihor you're using the wrong Decision Tree. The one you have pulled in is the Decision Treet Multiway, which requires another model producing operator inside. 

  • ihor
    ihor New Altair Community Member

    Thank you for the quick answer, now I feel really bad about not having seen the simple Deciding tree option,

    everything worked out so thanks again:)

Categories