The Siemens Community Catalyst program was co-created with our community to acknowledge technology leaders who consistently contribute to the Siemens Community. Nominations are accepted on a rolling basis.
hello everyone,
I have faced an error when doing Hyperworks cfd tutorial Acu-T-5403 DCFSI.I have completely followed the tutorial step by step.
The AcuSolve and OptiStruct solver started and coupled together.
However, after a few time steps, it shows an error:
I checked your model and found some errors in it, and I think they are the reasons that stop your from your analysis:
1. Define the eddy viscosity for the inlet.
2. Set Socket host as localhost
3. surface was not selected for z_pos in Planar Slip.
Thank you, James Lewis! Your input and corrections for the tutorial are greatly appreciated. With your help, the analysis is now running smoothly.
Join us for a Community Conversation where we'll discuss practical approaches to analyzing complex electromagnetic models using hybrid solver techniques. This session will provide a general overview of how different computational methods can be combined within a single simulation to address models containing varied…
Join us for a community conversation to explore how different modeling approaches in Simcenter PSIM can help engineers simulate power electronics systems while balancing accuracy, simulation speed, and design insight. What you'll learn: Power transistor modeling : Thermal and high fidelity models Protection component…