FMU Export from Flux 2D to Activate results is not feasible
Sundaravalli
Altair Community Member
We used CreateLookUpTableFromTMProjectDQLight.PFM macro for IPM motor and generated FMU block (input - Id, Iq & angular position, Output - flux A, B, C). We used FMU in Activate as well as Matlab to see the Flux A, B, C output Waveform, which is symmetric and has zero offset-but discontinuous and not a sinusoidal. See attached image for flux-a with constant id=-200, iq=200 and theta varying from 0 to 2*pi.
Tagged:
0
Best Answer
-
Hi Sundaravalli,
We had the same request in service now and it is resolved.
Thanks and regards
Karun Teja
0
Altair EmployeeAnswers
-
Please refer attached image for flux-a with constant id=-200, iq=200 and theta varying from 0 to 2*pi.
0 -
Hi Sundaravalli,
We had the same request in service now and it is resolved.
Thanks and regards
Karun Teja
0