Problem with the results of HyperGraph

Sujay Pattiwar
Sujay Pattiwar Altair Community Member
edited June 2021 in Community Q&A

I am performing a Direct Frequency Response Analysis on a Flat Plate for practice. I have requested the results for three nodes. But when I click on OptiStruct the software throws me directly to HyperGraph instead of HyperView. Even when the HyperGraph is opened the results are shown for a single node only instead of three nodes. 

I am using a student version of HyperWorks for this analysis. 

PFA of the model file of the Problem Statement

Thank You.

Tagged:

Answers

  • Rogerio Nakano_21179
    Rogerio Nakano_21179 New Altair Community Member
    edited April 2021

    Hi

    Likely you are opening the session *.mvw created as the analysis of OptiStruct is finished. With that, each node data is saved in separated pages.

    Likely you have three HyperGraph pages, one for each node.

     

    if you want to see the model in HyperView. You can add a page and load the *.h3d file generated by the analysis.

     

    I hope this helps you.

    Regards

  • VENKATA SAI KUMAR MADALA
    VENKATA SAI KUMAR MADALA Altair Community Member
    edited June 2021

    The same problem is occurring for me while performing frequency response analysis problems. You can see in the images. When analysis is completed by clicking on results it directly opening in hypergraph and i cant able to see the displacement in HyperView also. Also cant able to open .mvw file in hyper graph. could any one help me to resolve it and fix that issues?

    image

    image

    image

    image

  • Sujay Pattiwar
    Sujay Pattiwar Altair Community Member
    edited June 2021
    Rogerio Nakano_21179 said:

    Hi

    Likely you are opening the session *.mvw created as the analysis of OptiStruct is finished. With that, each node data is saved in separated pages.

    Likely you have three HyperGraph pages, one for each node.

     

    if you want to see the model in HyperView. You can add a page and load the *.h3d file generated by the analysis.

     

    I hope this helps you.

    Regards

    Hello Sir, Actually I'm getting only one result, when I try to open the *.mvw file the HyperView closes itself. I'm using a student version of HyperWorks. Is this the problem with the student version?

  • Rahul_P1
    Rahul_P1
    Altair Employee
    edited June 2021

    You have to click on View 

    image

     and then choose the required result file before clicking on the results button

    image

    you can also open HyperView and then open the result file from the run location as well

     

Categories