Hey Everybody,
I started working with hypermesh about a few months ago. I now notices that my .out file has changed a little bit ever since.
For a modal analysis, before the 'Subcase Mode Frequency...' Section there is a new block, that has never been printed before.
I looks like this:
Design Volume Fraction = 1.00000E+00 Mass = 1.61845E-02
Discreteness Index = 1.00
Density %
-------------
0.0-0.1 0.0
0.1-0.2 0.0
0.2-0.3 0.0
0.3-0.4 0.0
0.4-0.5 0.0
0.5-0.6 0.0
0.6-0.7 0.0
0.7-0.8 0.0
0.8-0.9 0.0
0.9-1.0 100.0
I assume this has something to do with optimization settings, however, I only performed a modal analysis without any optimization settings.I also checked the 'Optimization View' in the model tab but the only thing defined here is my load case. I checked with other models and this seems to be normal. I didn't define any other optimization parameter.
Usually this block should look like this:
Volume = 1.13360E+06 Mass = 1.63998E-02
I don't know what setting or modification on my model has let to this changes in the output and I'm curious to get some ideas on why this cold be happening.
Thanks for any suggestion!
Best regards
Leon
