A place to ask questions about Altair products or solutions and receive help from community members or Altair employees
Hello there, I am using CCS project generated from PSIM and running it on TI Launchxl-F28379D, there I have SCIB (a module that was put in using PSIM). I want to use this SCIB to communicate between two Launchxl-F28379D but its not working. I watched couple of videos where SCIA was being used to send a data from a PC that…
I am trying to understand what S-Foundation is doing when you say a footing is rigid versus flexible. To this end, I have a simple 5m x 5m x 1m (thick) footing as shown in my attachment subjected to 1072 kN force. I run a linear static analysis with both flexible and rigid options. For the flexible case, I have set the…
Hi EDEM expert, I have a question on the force controller in EDEM geometry motion setting. The documentation (https://help.altair.com/EDEM/topics/creator_tree_geometries/specifying_a_force_t.htm?hl=specify,force,controller) on this is not very clear: "Select a Damping Coefficient value from the Damping Coefficient list.…
Hey, I want to run a coupled simulation with EDEM and fluent, I want to count the number of particles on each wall. I specifically want to see the total number of particles that hit the wall and the number of particles that stick to this wall. (I know that I can count the number of particles that stick to the wall) Thanks,…
I am using a laptop with Ryzen-7 after all installation which is needed for nanoFluidX the product is not opened. There is any other process for installation for CPU laptops?
Dear all, I'm running a model reduction and I would like to extract the reduced matrices as a .pch file (ASCII format) when using CMSMETH GM (General Method). When I use the CMSMETH CBN (Craig Bampton Nodal), the matrices are correctly output (I am using PARAM, EXTOUT,DMIGPCH and PARAM,MASSDMIG, to print the corresponding…
File is attached which is displayed after complete installation. Can you please share complete installation video.
Hello, is there any training available to learn morphing with the new 2024 Hypermesh GUI? Or does any of the training which are listed on the Altair site at the moment contain training on how to morph in 2024? Thank you!
I have a new device and I wanted to use it for studying, since I no longer have the old one. I installed the necessary programs again, but when I try to enter the license, I get an error saying that the license is already in use on another device. Now, I don't know how to deactivate the license from the previous device…
How to setup a FLUX model to measure the magnetic force of a magnet array at different gap distances?
There's a wealth of content waiting for you to explore! Need support or have a question? Login or join our community.