A place to ask questions about Altair products or solutions and receive help from community members or Altair employees
In HyperView when I create a contour and want to get the list of all values from the contour, I use the TCL command, myContour GetValueList In 2023.1 version Python APIs for HyperView and HyperGraph are created Hence looking for the python equivalent for the same! A few examples or documentation to refer might be very…
Hi Good Morning, I performing a Conjugate heat transfer analysis. In our model we have a motor, for stator and armature shaft we know values of Resistance and current. Now, In sim lab there is three possible ways to feed the heat source values and I attached the image below. So My doubt is how I consider the heat source of…
Hello everyone, I am designing a yagi antenna with 3 magnets with S11<-10dB requirement at 1700-1900MHz but I can only meet the requirement at 1700MHz and not at 1900Mhz, can you help me? Can you help me how to adjust?Thanks.
Can someone tell me how to "switch modes" in HyperWorks CFD to use ultraFluidX rather than AcuSolve? Whenever I load HyperWorks CFD, I see no options for ultraFluidX or aeroacoustics. The window title always reads Altair HyperWorks 2024.1 - CFD - AcuSolve. I am essentially hoping to find the Virtual Wind Tunnel…
Hello, I have followed all the steps to download as a student S-Concrete, when I open the software the error message ''Error #380 Invalid Proprety value'' keeps popping up and I cannot do anything in the software. How can I make it work? I also have another computer I could use instead, but to do so someone would need to…
Hi there In the new hyperview 2024.1 when model exported as GLB and output format is in PPTX is it possible to display labels as well when the user exports the results from hyperview with current option the labels are missing Or is this option still not supported from Microsoft ?
Hello expert, I would like to export the geometry from Flux3D to our CAD software in order to integrate the motor in our system. Is there a way to also export the non meshed coil as displayed regardless of possible collisions ? Thanks you,
Where did all of the Altair University content go? I cannot find anything related to altairuniversity.com after the Altairone transition.
Dear all, Does anyone now how to export only the mass matrix of a structure while avoiding to write the stiffness matrix to the same file? I am using OUTPUT,MATRIX,FULL,SPARSE, which writes the stiffness and mass matrix to the same ASCII (.full.mat) file. However, since I have a big model, it is taking ages to write the…
Hi, I am looking for the /ALE/LINK/VEL/ keyword in hypermesh. I did not find it and use it manually. It looks like hypermesh does not recognize it when it is imported from a rad file. Thank you for your help, Clément
There's a wealth of content waiting for you to explore! Need support or have a question? Login or join our community.