A place to ask questions about Altair products or solutions and receive help from community members or Altair employees
Hi Team, We are trying to run a Radioss simulation, which is taking longer time on AMD processor compared to Intel. And also, when the same run is carried only on AMD processor with multicore usage, 32 cores is taking lesser time than 64 cores whereas to happen vice-versa. For example, 32 cores AMD processor is taking 0.5…
Hello, Earlier this year, I downloaded the Student Edition License for Altair Inspire 2024.1 on my old laptop. Recently, I received a new laptop and would like to install Inspire on it. However, I’m unable to deactivate the license on my old laptop since I no longer have access to that device. I attempted to use the same…
Hello, I’m trying to renew my PSIM student license, but I’m encountering the issue shown in the attached photo. When I try to activate it, I receive the following message: Do you have any suggestions on how to resolve this? Thank you
Hello all, I have been trying to call a python script located in a directory with Tcl exec command in HyperWorks 2023 which doesn't give me the desired execution. How can I call another .py script from .tcl script file? Kindly give out some ways to work this out. Thanks in advance, Thirukumaran
I am using simlab and acusolve to measure air flow through an accumulator. The mesh is created ( as you can see) but for some reason I get this message when I try to update the study. Any idea what I did wrong or how to get around this?
How to define V2 bond creation time in custom factory?
Hi Good Afternoon, I want to perform the stress analysis for the below mentioned Handle Model. The Handle contains two parts, Top and Bottom. these are connected using Screws ( shown image) . Apart from screw joint, the two parts are mated each others. Full Model ( Top cover is in transparent view) Top View ( For Screw…
I modeled using PCOMPP and trying to view ABD matrix but the Engg. constants are under zones. Is there a way to figure out what elements are under a given zone?
For Reference, This Is A School Group Project I initially had trouble getting the model initiated through the solver. After reworking the model in SolidWorks to close all gaps and turning an assembly into a single part, simulations ran better than before. I set the values of the reference length as the length of the entire…
I am currently trying to simulate air flow through an accumulator and I set up where the air flow is simply entering one side and exiting the other. I used essentially the default CFD Mesh, only inputting the element sizes. I also used the whole body as a fluid body(not sure if it makes sense to do that). However when I…
There's a wealth of content waiting for you to explore! Need support or have a question? Login or join our community.