No results in h3d format after solving in Radioss
Hello!
I am writing my thesis for the next month. My Thesis is based on a Master Thesis Simulation in HyperWorks which is completed a few years ago.
Since there is no complete Data of the Simulation (only in written Form), I have to reconstruct it. And to validate it, I need to see my Results and compare this with the results of the Master Thesis.
The Master- Thesis used HyperWorks, Radioss in BulkData 110 Format.
At the end in it, it shows, that the results exported in h3d Format to show the results in HyperView.
My reconstrutive Simulation had no error messages after solving with Radioss. But if I export the results in h3d Format and try to open it in HyperView, he give me an error message, that there are no results available!
That´s a big Problem for me, ´cause I cannot verify the results.
Hope someone can help me and I´m looking forward to answer all question that can help solving this problem.
Greetings
P.S. I wasn´t sure if its should be posted in 'Radioss' or 'HyperView' Forum.