unable to generate h3d file
After completion of normal mode analysis , there is no h3d file generated.
Find more posts tagged with
Altair Employee
No modes exist between your frequency range and that is the reason no h3d file is generated.
Please request modes with just ND on EIGRL and check if that helps.
sir, there is no h3d file generated even after following the above method.
i have attached .out file
Dont mention range of interest and extract using ND (Number of modes to extract).
Altair Employeehow can i establish connection between members , if they are not connected and comes out from geometry during modal analysis ?
Altair Employeehow can i establish connection between members , if they are not connected and comes out from geometry during modal analysis ?
It depends on how complex the problem is. You can connect elements nodally by equivalencing. If there is no node within the tolerance, then you may have to trim the element and make room for a node and connect
Hi @yogeshchandra
Can you let us know which version of HyperWorks are you using and updates installed?
If possible, please share the model file.