Contact error
Hello,
I have been trying to define contact between two cylinders on their flat faces.
But I am getting following error. <?xml version="1.0" encoding="UTF-8"?>
What is the remedy for this error
Regards
Bharat
Find more posts tagged with
Hello Rahul,
version is 13 . Type non linear quasi static.
Thanks and regards,
Bharat
Increase the SRCHDIS value in CONTACT card. (if not entered earlier, default will be twice the average edge length on the master surface)
Altair EmployeeIn contact interation there are two compoennts. Tangential and normal. I think this is the problem in your case
Check the contact modelling for cotact group ID 3.
Hello,
@ Rahul - my elements have very small gap. They are like almost touching each other.
@Prakash - I am unable to find the components you are talking about. Can you help a bit on that?
Thanks and regards
Bharat
Altair EmployeeBharat,
From the error message I can see the issue is with contact group ID 3. Try to recreate contact interface for the same.
Altair EmployeeBharat,
share the deck file, please
Sorry Prakash,
can't send you that.
My mesh on one cyilinder's face is matching with other. Is that causing the problem?
Regards,
Bharat
Which version of Hyperworks you are using & type of analysis ?