🎉Community Raffle - Win $25

An exclusive raffle opportunity for active members like you! Complete your profile, answer questions and get your first accepted badge to enter the raffle.
Join and Win

Trouble with Tie contact

I have two 2d meshes approximately .132in apart but where the laminates will contact each other. I have been trying the tie surface contact but when I run the simulation there is no load transfer from one part to the other.

 

Is there any other way to perform this or something I should be looking out for in particular? 

 

Thank you for any advice regarding this subject. 

Find more posts tagged with

Sort by:
1 - 8 of 81