missing result file
Hello,
I want to simulate the torsional stiffness of a beam, which is welded (RBE3) to two plates.
For some reason the calculation is successful, but there is no H3D- file, which I could review in Hyperview.
I attached the fem-file as well as the out-file.
Can you help me to figure out, why there are no results for this calculation?
Thank you guys in advance,
Tim
Can you just rename the file and run again. After renaming shared file runs fine at my end.I am using OptiStruct latest version 2018.0.1
Unable to find an attachment - read this blog