missing result file

Altair Forum User · January 2019

Hello,

I want to simulate the torsional stiffness of a beam, which is welded (RBE3) to two plates.

For some reason the calculation is successful, but there is no H3D- file, which I could review in Hyperview.

I attached the fem-file as well as the out-file.

Can you help me to figure out, why there are no results for this calculation?

Thank you guys in advance,

Tim

Rahul Rajan_21763 · January 2019

Can you just rename the file and run again. After renaming shared file runs fine at my end.I am using OptiStruct latest version 2018.0.1

Altair Forum User · January 2019

Thank you very much.

Is Ä the problem?

Rahul Rajan_21763 · January 2019

yes I think so.

Welcome!