Apply load

Altair Forum User

Hello All,

I am using radioss to analysis cylinder. I am applying Concentrated load and this load does not have any effect and I do not find any stresses on the part in the Hyperview. 

I made curve (x= 0,10,25,250 & Y=0,0,0.02, 0.02) and apply it to a node in the center. 

Kindly, find the file attached below.

Unable to find an attachment - read this blog

Simon Križnik

Hi,

 

in the model you have shared the load is actually applied to nodes which are constrained by the rigid. 

The load should be applied only to the master node of the rigid.

Unable to find an attachment - read this blog

Altair Forum User

Thanks, I fixed it /emoticons/default_smile.png' srcset='/emoticons/smile@2x.png 2x' title=':)' width='20' />