Qvol/Qbody depend on Node temperature in Heat Transfer Transient

Junta_20361
Junta_20361 New Altair Community Member
edited October 2020 in Community Q&A

Hi expert,

I am using OptiStruct to perform a transient heat transfer analysis.
I know that it is able to define a thermal load (Qvol/Qbdy) varying with time (time dependent).
But is it possible to create a thermal load which is depend on a specific node temperature?

Thank you!
image.png.082c4ee6b58365b4c312b7e3d80e0422.png

Answers

  • Rahul Rajan_21763
    Rahul Rajan_21763 New Altair Community Member
    edited January 2020

    Time varying convection

    • Convection coefficients can be specified as time-dependent when a control node (CNTRLND) is specified on CONV card.
    • The control node must be constrained by an SPCD, which is made time dependent by TLOAD1/TLOAD2. The convection coefficient is multiplied by the value from SPCD of control node.

Welcome!

It looks like you're new here. Sign in or register to get started.

Welcome!

It looks like you're new here. Sign in or register to get started.