Dear Team,
In the e-drive motor control project (open-loop and closed-loop), we initially worked with Launchpad F280049C mcu using the GANINV board, and the system was working fine….In this setup, the *main motor control is executed on interrupt, configured with *ADCBINT1 and EOC2 mode.
Later, we converted the same project to the Launchpad F28P550SJ mcu using the GANINV board. However, in this case, the *main motor control interrupt is triggered only once…In the setup, the main motor control is executed on interrupt: ADCAINT1 and Mode: EOC2.
Additionally,we have also attached the VSM files.
help us to identify the reason for this issue and guide us on how to resolve it.
Regards,
Reshmi Team.
