[SOLVED]Editing a list for the Map Operator using XML
New Altair Community Member
Updated by Jocelyn
I need to create a mapping, but the list of parameters is so large, that I wouldn't dream of doing it using the Parameters View. I used to do it in the XML code and then click the green check mark to apply to the main process.
But now it is not working! I click the check mark, but when I go back to the Process View, the list has not been added. If I go back to the XML, it is still in there, but it will disappear if I close and open the process again (even if I make sure to hit Save). I feel like I must be missing something very very simple, since this always worked, I just can't figure out.
The only thing that changed since I last tried this, besides my RapidMiner version, is that now I am in a Swedish computer. Could the encoding have anything to do with it? (the list has a lot of Swedish characters).
Thanks for any comment and suggestions.
But now it is not working! I click the check mark, but when I go back to the Process View, the list has not been added. If I go back to the XML, it is still in there, but it will disappear if I close and open the process again (even if I make sure to hit Save). I feel like I must be missing something very very simple, since this always worked, I just can't figure out.
The only thing that changed since I last tried this, besides my RapidMiner version, is that now I am in a Swedish computer. Could the encoding have anything to do with it? (the list has a lot of Swedish characters).
Thanks for any comment and suggestions.