Optistruct Solver View doesn't show up

MaxB

Hello,

 

i am new to Hypermesh/Optistruct and i started my training with a youtube tutorial about the topology optimization of a bridge (https://www.youtube.com/watch?v=RcbsMz81bPs).

 

so here is my problem:

after setting up the model i hit the optistruct button but nothing happens. In the bottom left corner of the hypermesh window there is some action going on but after a few seconds it says 'ready' and no window of optistruct or the optistruct solver view is showing up. I guess optistruct never started the analysation process. But there is no error.

 

Can someone help me with this? I uninstalled the application and installed it again with a new downloaded file but this did not solve the problem. I am working with the student version of HyperWorks 2019.

 

Thanks in advance,

Max

<?xml version="1.0" encoding="UTF-8"?>

Rahul Rajan_21763

Please don't use any special character while saving file or during analysis. I see you used brA1/4et as the name.....Just save file as bracket. It should run the analysis.

Prathamesh1225

Hello,

I didn't use special characters, I am using hyperworks 2019 - student edition. When I click on Analysis>optistruct, .fem file is created and it shows ready at bottom, solver view don't show up. I read many posts related to this issue, and below are the things that I tried -

 

1. Avoid using special characters

2. use .fem extension.

3. re-install the software 

4. Change read only directories to not read only in program files folder.

 

Please help me with this

<?xml version="1.0" encoding="UTF-8"?>

Adriano A. Koga

i would avoid running in folders and using filenames with 'space' on it.

Can you rename your fem file and try running in somewhere like: 'C:/temp/carm.fem'?

Prathamesh1225

Hey Adriano,

I tried to save it in C drive, It didn't work.

Adriano A. Koga

are you sure there`s no error message in the bottom left when you try to run your model?