Altair RISE

A program to recognize and reward our most engaged community members

Nominate Yourself Now!

Error exporting solver deck for Radioss (duplicate control cards not allowed)

Hi,

I am attempting to export the solver deck for Radioss through HyperMesh and receive a pop-up error "Error: 0" and in the bottom left-hand corner the message "Duplicate control cards not allowed within the same include."

I have double-checked that the control cards I have in the model aren't duplicates and I have previously exported the solver deck for an earlier version of the model without any issue (I did delete one control card (ENG_RFILE) and make some minor edits to the other cards (ENG_RUN, ENG_TFILE, ENG_ANIM_DT), but no changes that I have previously had any issues with). I have attached a screenshot of the error messages when attempting to export the solver deck, but do not know enough to understand exactly what the issue is... is there something I can change to successfully export the solver deck?

Thanks in advance for any help.

Find more posts tagged with

English

HyperMesh

Radioss

v2020.0

Accepted answers

Rogerio Nakano_21179

Could you check if there is any keywords on card "unsupported cards" , if any.

Check if they are needed, if not delete the unsupported ones. And give the exporting a try.

I hope this is helpful

Regards

All comments

Rogerio Nakano_21179

Could you check if there is any keywords on card "unsupported cards" , if any.

Check if they are needed, if not delete the unsupported ones. And give the exporting a try.

I hope this is helpful

Regards

Autumn

Hi,

I was able to determine that there was an issue with the ENG_RUN card by going Analysis > Control Cards and going to the page with this card (it was highlighted in red instead of green). After deleting it and adding it again the export was successful.

Thanks.