🎉Community Raffle - Win $25

An exclusive raffle opportunity for active members like you! Complete your profile, answer questions and get your first accepted badge to enter the raffle.

Join and Win

Analysis Error0 when I try to Analyze a structure

Luca Fedeli

Goodevening,

whenever I try to perform an Anlysis simulation of some structure, it never ends in the right way. It pops out the message "Analysis Error0 Contact www.altair.com/customer-support".

Moreover, when I try to Optimize the same structure, it pops out another message:

What should I do? I'm desperate while the software needs me in academic uses.

Find more posts tagged with

English

Inspire

v2023.1

Accepted answers

All comments

GTT Adam

Hi Luca,

Can you share the model you are trying to do this analysis with?

Thanks,

Adam Reid

TonyG

Hi Luca

To check if it is a modelling or an installation issue can you do the following.

1. open the Demo browser (F7 or view>demo browser)

2. open the model Baseline Analysis.stmod in the structures folder by double clicking it. This model is ready to run with all loads etc set-up.

3. Run an analysis.

If this model runs with no errors then the issue is probably in your model/model setup.

If it doesn't run likely an install or permissions issue.

Tony