The Siemens Community Catalyst program was co-created with our community to acknowledge technology leaders who consistently contribute to the Siemens Community. Nominations are accepted on a rolling basis.
How to tie two faces or two nodes sets in Simlab for Abaqus solver? The command "connect" is not working properly (the card generated *equation is empty)
Hello Emanuele,
Please use "Connect Faces" tool which is available under Analysis > Loads and Constraints > Connectors as shown below.
This will write the *equation card in the solver input file.
Thanks & Regards,
Santhoshkumar
Join us for a Community Conversation where we'll discuss practical approaches to analyzing complex electromagnetic models using hybrid solver techniques. This session will provide a general overview of how different computational methods can be combined within a single simulation to address models containing varied…
Join us for a community conversation to explore how different modeling approaches in Simcenter PSIM can help engineers simulate power electronics systems while balancing accuracy, simulation speed, and design insight. What you'll learn: Power transistor modeling : Thermal and high fidelity models Protection component…