optistruct 2020 - Where can I find PERBC and RELOC

Sitou_21548
Sitou_21548 Altair Community Member
edited April 2021 in Community Q&A

Dear All,

I'm doing RVE homogenisation and i have to apply some periodic boundary condition.

By searching, i find that it can be done with PERBC and RELOC but i search and don't them.

Could somebody please tell me where can I find them?

Thank you all

 

Sitou

 

Tagged:

Answers

  • Gildas_GUILLY
    Gildas_GUILLY
    Altair Employee
    edited April 2021

    Hello Sitou,
    PERBC and RELOC cards are currently not supported in HyperMesh, you will need to define them as BULK UNSUPPORTED CARDS.
    FYI, There is a document on the knowledge base talking about Periodic Boundary Conditions :
    KB0081409

    Gildas

  • Sitou_21548
    Sitou_21548 Altair Community Member
    edited April 2021
    Gildas GUILLY_21156 said:

    Hello Sitou,
    PERBC and RELOC cards are currently not supported in HyperMesh, you will need to define them as BULK UNSUPPORTED CARDS.
    FYI, There is a document on the knowledge base talking about Periodic Boundary Conditions :
    KB0081409

    Gildas

    Thank you Gildas for your reply,

     

    I'll check the document you preconise.

    Best regards

    Sitou

Categories