Inspire Form simulation does not make any progress, even though there is no error

rm_21223
rm_21223 Altair Community Member
edited March 12 in Community Q&A

When I launch a simulation on Inspire Form it progresses up to 50%, but then stays at this point indefinitely. There is no error message and on the run folder the CurRunStatus.xml file is the only one to be updated.

image

 

The c2f.log does not display any message:

image

 

How could I solve this?

Tagged:

Answers

  • Saurabh Bhamania_22275
    Saurabh Bhamania_22275
    Altair Employee
    edited March 12

    Hi,

    You can check the results till this time step by clicking on the run and select view now, to check if the part forming without any issues or the blank mesh got distorted and resulting in higher thinning%.
    If the blank is showing higher thinning %, then check the tools CAD and the setup again.

    Thanks and Regards,
    Saurabh

Categories