Multiple Single setups in a single solving Scenario

Matthias Strässle
Matthias Strässle Altair Community Member
edited August 2021 in Community Q&A

Hi, 

I am trying to set up a solving process where multiple frequencies are solved but with single slip values for each frequency.

For example, I want to solve for 270 Hz with 1% slip and 200V and for 2000 Hz with 86% slip and 100V. Is this possible to set up in a single solving scenario or do I have to use multiple solving scenarios? 

 

Best

Matthias

Tagged:

Answers

  • C_Favre
    C_Favre
    Altair Employee
    edited August 2021

    Hi,

    It is possible to create this type of scenario using tabulated parameter. To do that you need to firstly create a parameter piloted by a scenario (named PILOTE for example) that you will varied using a solving scenario by step of 1 . After that you have to create  two parameters SLIP and FREQUENCY defined as tabulated parameter with PILOTE defined as abscissa (see pictures attached).

    once it is done you can create a scenario to varied PILOTE from 1 to N to solve  the N configuration (see pictures attached)

    In this case when PILOTE will be set to 1 during the solving the value of the parameter FREQUENCY used will be the value specified in the first line of the tabulated parameter, when the value of PILOTE will be modified, the values of Slip and Frequency will be also updated.

    I hope this helps.

    Best regards

    Cyril

     

     

Categories