Error 1000
Answers
-
Hi Abhinav,
Go to 2D panel and you can use Drag nodes/elements to create elements, but make sure you do this in glass fiber component.
Manufacturing ply thickness is ignored in freesize and whatever PLYMAN/TAMNF you provide will be carried to size optimization phase.
You can provide different manufacturing ply thickness by editing the PLY>> TMANUF>>VALUE
0 -
Hallo Prakash,
I tried creating a new element like you advised with drag. I did get the element created however it creates two elements. I have given the settings as -2.5mm distance, drag 1. Even after equivalence it doesnt work. I am still having an unwanted elemnt, even if i try to delete , it deletes both the elements since it takes it as a whole one element
With Regards
Abhinav
<?xml version="1.0" encoding="UTF-8"?>
<?xml version="1.0" encoding="UTF-8"?>
0 -
Hi Abhinav,
You can delete the elements and create single elements using create element (F6) just by selecting surrounding nodes.
0 -
Hallo Prakash,
that didn't work for me either. I cannot select the nodes on the ply. When I create these elements they are not on the desired ply.
<?xml version="1.0" encoding="UTF-8"?>
0 -
Hi Abhinav,
Can you share the model file, please?
0 -
did you receive it?
0 -
i have sent two times sinces its shows session expired again and again.
0 -
apart from that, is it possible to check the energy absorbed by the structure?( internal energy )
0 -
..
0 -
0
-
I have downloaded it, but it didn´t somehow solve the issue, which I wanted.
If you try on some ply from the top laminat lets say PLYS_104101, it doesnt work out.
<?xml version="1.0" encoding="UTF-8"?>
0 -
Abhinav,
Please check the normals.
If the normals are fine, I would suggest you to update the elements for plies.
0 -
Hello,
I am Hardik and i am getting error like ' ERROR # 1000 *** in the input data:
Incorrect data in field # 3' this and Too many error messages. Aborting run.
Current limit is 10000. Use 'MSGLMT' control card to change this value.what should i do.
0 -
Hi Hardik,
Please share .fem file?
0 -
Hello Rahul,
i already send you d .fem file.did you receive that or not?
0 -
What you should do is assign property for the tetra component
please check other component also.
0 -
Hello Rahul,
It was my mistake and i send you again the .hm file.Please check it out.
Thank you,
Regards,
Hardik0 -
0
-
Hello,
I am getting some problem regarding assigning property to mesh.I don't understand how can i assign property to mesh because i have three different material with that three different property and i tried with all this three property but then i am getting error 78.So i don't understand which property i will assign and with which material
Thank you
Hardik
0 -
maybe you assigned 'PLSOLID' while it should be 'PSOLID'
please refer to
0
Altair Employee
