Material modeling for adhesive using MAT LAW83
Altair EmployeeHi,
I am a masters student trying to fix parameters in for material model LAW83. For adhesive bonding between two dissimilar metals.
Please help me out with the LAW83 material guidelines, and a suggestion for failure model(tried SNCONNECT).
Regards,
Chaitanya.
Answers
-
Hi Chaitanya,
Can you refer to the RADIOSS reference guide for details, instructions and suggestion for LAW 83?
If you have any problem in defining, please let us know.
0 -
Hi prakash,
I have refered to the MAT83 and have set the required parameters, but my results were not convincing.
I have seen that young's modulus has been normalised as per unit length. Is this varying as per the adhesive thichness?
From the material testing I got E=0.43 GPa.
Thankyou.
0 -
You should try same on Version 14.0.See attached screenshot for enhancement for MAT83 in version 14.0
<?xml version="1.0" encoding="UTF-8"?>
0 -
Altair Forum User said:
You should try same on Version 14.0.See attached screenshot for enhancement for MAT83 in version 14.0
<?xml version="1.0" encoding="UTF-8"?>
Thankyou for the update,
I am still facing problems determining the FCT_ID1 curve. I have taken the lap shear speicmen (Stress VS strain curve), normalized Y axis (stress) and from the manual altair partners have provided the details of normalizing of strain are not clear. could you kindly help me.(Please find my curve data attached)
Regards,
Chaitanya
<?xml version="1.0" encoding="UTF-8"?>
0
