Issue with Capture Peripheral Example When Using Different GPIO Pins

Luis Pedro Carvalho

Hello everyone,

I'm currently trying to use the Capture Peripheral with interrupt  example provided by PSIM, and it works perfectly when I use GPIO 0(the channel set in this example). However, when I attempt to use different GPIO pins (specifically GPIOs 124, 122, and 58), even after configuring these channels in the interrupt, the simulation does not work.

Has anyone encountered a similar issue or have suggestions on how to properly configure these GPIO pins for the Capture Peripheral? Any advice would be appreciated!

Thanks in advance.

Jack_2nd

Hi

Can you please give us a simple schematic so I can try it out.

Thanks,

Jiakai

Luis Pedro Carvalho

I'm sending it as an attachment

Jack_2nd

Sorry for replaying late.

I have tested the schematic on PSIM v2024.0, v2024.1 and v2025.0, all of them work fine.

Could you please download a newer version of PSIM to try it again?

Thanks,

Jiakai