A place to ask questions about Altair products or solutions and receive help from community members or Altair employees
Hello everyone Is it possible to design an axial flux motor with either flux 2D or flux motor (specifically flux 2D)? If yes, how do I go about it? Thank you for your assistance.
Hi all, when carrying out a trial simulation to get familiar with the program, an error appear when creating the final volume mesh in order to solve ths simulation. Anyone knows potential reasons to this error, and any solution? Thanks in advance!
Where can I found more detailed methodology or code of this example? Presentations & Webinars - Webinar: Experimentally Validated DEM Model of a Triaxial Test on Railway Ballast Utilizing the Multi-sphere Approach (altair.com)
I am measuring the frequency deviation in a microgrid operating in islanded mode during load changes. Currently, I use a Phase-Locked Loop (PLL) block to measure the system's frequency. However, despite following the PLL Help instructions for calculations, I notice significant ripple in the frequency output (as shown in…
I have a question regarding the Non-Structural Mass (NSM). When we define NSM for different assemblies, all the NSM appears to be consolidated into a single assembly during mass checks. The NSM was created using element sets, and I would like to know if this is a tool issue. How can we verify whether the mass has been…
I recently got a student license for PSIM and activated the license but due to changing my PC, now I'm trying to activate the license again, on another laptop, but I get an error warning saying "This license was already activated using different HostIDs". Is there something that can be done for me to activate my license?
Hello I want to simulate active clamp flyback PFC for low power application around 400Watt can you please assist me for this or you can also provide Forward PFC or push-pull PFC simulation I want to learn I am university student. Thanks for your help and support Best regards Bush
Hi, I am trying to utilize simcoder on PSIM but when I first set it up, I did not click code generation on the License Setup page. When I open License Setup now, I am unable to click to add any new features (see screenshot). I have gone through the authorization process with altair one multiple times but I am still unable…
i am facing issue while running dynamic analysis on motionview.
There's a wealth of content waiting for you to explore! Need support or have a question? Login or join our community.