Composites - Radioss
Altair EmployeeHi everyone,
I have to simulate an object made by thermoplastic composite laminate. I know that I have to do a model calibration with a fitting of experimental curves but I have a lot of doubts about the correct procedure.
For exemple on the one element test I have to define laminate and plys or I have to use a single ply with laminate's thickness?
Could anyone send me some material about composites model calibration?
Thanks in advance.
Marta
Find more posts tagged with
Altair EmployeeThanks @Rahul R for you replay.
I've seen the attached file: there b and n are calculate as 
but, I have to use CRASURV model, where b and n are calculate as 
(I don't know what Wpref is)
Furthermore I don't know HyperStudy, I'm using Hypermesh (Radioss).
Any other suggestion?
Thanks a lot
Kindly regards
You can refer attached documents for material calibration using HyperStudy.
Unable to find an attachment - read this blog