Error Found while simulating Convection (Heat Transfer)

Hi Nayak,

Looks like you did not apply a valid material/material card.

Please create a MAT4 card and refer the same in PCONV card.

Hey Prakash,

I already gave Temp 100 on top side and on the bottom side I have given 20 Degree cel. and I have select one Node in between my model and select as a 20 degree temp and make convection. I got error which you can see below pict:

<?xml version="1.0" encoding="UTF-8"?>

Hi Nayak,

In CONV card ambient temperature is missing. Please correct this and try again.

I have already apply ambient Temp. As mention in OS- 1085, and I took SPCADD Card for two different temp Load Collector. Top 100 degree and Bottom 20 degree and in between I Chose one Point for ambient temp which has 20 degree temp and make convection.

<?xml version="1.0" encoding="UTF-8"?>

Hi Nayak,

Slave set ID is missing in CONTACT card, please update and run again.

How can I edit Slave Set ID; I have seen in my Contact surface window but it doesn't Show anythings regarding Slave set..

It Shows only EID; GID1 and GID2 that I have already mention....

I got error like that : CONV ID  ::::::: CONV ambient Point TA must be in SPC set of heat Transfer subcase.

I have taken one node for ambient temp and given it ID 1000000 and HEAT TRANSFER is my Load step....

<?xml version="1.0" encoding="UTF-8"?>

Hello Friends,

I am doing Heat Transfer Analysis. I have both the cases- Convection and Convection. On the top of my Part there is higher Temp. Zone and there I have apply convection then High temp goes inside my Element and perform Conduction. Analysis also done with no Errors but I can't understand the result which I have found in Element Fluxes types. It doesn't make sense. It Shows my most of the part like Zero Heat flux... and I can only see top part has heat flux which has higher temperature.

Hi Nayak,

Can you check if there is any modelling issue?

How can I see/check the error from Modelling or not?