Meshing alone certain Points

Hi,

whats about fixed points (quick edit or point edit)?

If you need exact coordinates, then you can use Geometry->nodes->extract on line... generate nodes parametric on line (from 0...1). Afterwards you have to create the fixed points in Geometry->point edit->on surfs->pick nodes.

Regards,

Mario

Yap, thats what I already do, however afterwards I dont get the nodes of the mesh on that same position as the previous points where located. I am currently using the command Mesh --> create --> solid map mesh and there I go.

As far as I can see, the mesh is not fixed on the locations where the previous points where created.

The simple way is to cut your surface through these points.

Hello,

you can mesh the surfaces of the solid with (triangle) shell elements. This has taken into account the fixed points, otherwise something is going wrong.

At a second step you can tetmesh this shell elements...

Regards,

Mario

Hi,

he says ”points” but it means ”position” perhaps.

In panel solid map/general you activate ”along” and select nodes at the positions, your mesh will be mapped to these pos. When i mesh, i often use ”along elems” than ”along nodes” because can control mesh better, anyway if your mesh is simple, a long nodes is enough