simulation using stl file
Hello everyone,
I have a problem when import stl file into inspire cast. When i set up the problem, the 'open window' show up like this
<?xml version="1.0" encoding="UTF-8"?>
<?xml version="1.0" encoding="UTF-8"?>
And i can't set up the condition of the problem.
Thanks.
Find more posts tagged with
Sort by:
1 - 3 of
31
Hi,
I have read the c2c getting started document, it even uses stl file directly after import it into the software.
Like this post:
In inspire cast, i don't know how can it set up the condition if i only have stl model.
Thanks.
Altair EmployeeClick2Cast used STL files. Inspire Cast is a different interface with much more functionalities that works with geometry. I hope this helps.
Inspire Cast needs a geometry to setup a problem. Since STL is not geometry but mesh, Inspire Cast pops up the window so that you can import a geometry to work on.