How can I develop a peak current double integral sliding mode controller for a dc-dc converter?

the existing peak current examples are in DC-DC examples folder and then there is this tutorial video and these webinars about PCMC

Dear @Albert_Dunford,

Thank you very much for your answer. It will help. However, do the examples guide using double integral sliding mode control?

No, those examples do not have double integral sliding mode control. PSIM has a full library of control blocks, doing an integral and a bit of math is relatively straightforward. Is there a paper reference?

Dear @Albert_Dunford,

Thank you very much. Yes, there is a paper reference available for DISMC. I have attached the paper describing the control and the circuit I want to control. I want to supply a total current of 425 A from the battery and supercapacitor with 20% and 80% of the current contribution, respectively for 5 seconds. I am sorry, I am new to PSIM.

?

@Albert_Dunford and regulate the output voltage at 12-14.5V. This is to ensure that the system meets the vehicle cold cranking/starting currents.

Hello @Albert_Dunford ,

I hope you are well. Any feedback since I sent you the documents?

@Albert_Dunford

Hello, any feedback since I sent you the documentation?

Hello,
I'm a PhD student at the GREAH Laboratory at the University of Le Havre Normandie in France, where I'm working on energy management with PSIM. My subsystem is PV+Battery+Charge but I can't control the voltage of my DC bus through my BUCK-BOOST chopper. If anyone has an idea or similar work, please share it with me to continue my work.
Thanks in advance.

@Mohamed lamine Touré what control algorithm are you using?

Hello,
I use the MPC on the PV side and a PI loop regulator in cascade on the battery side.

Hello,
I use the MPC on the PV side and a PI loop regulator in cascade on the battery side.

Hello, I want to do energy management between PV and Battery. PV connected to a Boost and Battery to a Buck-Boost. I can't stabilize the DC bus voltage (1000V). Can anyone give me an idea? How is a DC bus modeled in PSIM. On matlab it works, but I want to develop my system in PSIM.

Thanks for your help.