No Hypermesh after Installation

Hi,

I installed the Hyperworks student edition 13 today. Everything seemed to go smoothly as I closely followed the instructions. After the installation is complete, I open Hyperwork(hw.exe) and can only change the template to Basic FEA, Optistruct, Radioss - just the analysis tool but not to Hypermesh.

So then I went to check the installed files and tried to open the 'hmopengl.exe' in the hm folder. It didn't let me and prompted numerous errors of 'some hg files not found'.  I'm guessing hg means hypergraph.

Anyhow, I hope you get my point. Basically, I can't open the hypermesh after installation. Any help would be greatly appreciated.

Thanks,