Filling the holes with mesh

Altair Forum User

I am very much new to tcl .. It would be highly appreciable if anyone can help me with the logic

 

I have a model and it somewhat looks like the one shown in the figure. the free space shown at the centre is also not exactly as that shown in the pic. It can be of any shape. The shape of the free space can be an hole or in a zig zag manner also.

 

My OBJECTIVE is to fill this free space with MESH.

So my logic is to find the free edges and mesh the center free edge area. Can anyone please give me some clue how to proceed?

Is there any similar type of tcl available in script exchange? 

<?xml version="1.0" encoding="UTF-8"?>

Q.Nguyen-Dai

Can you do that in interactive mode?

Altair Forum User

I did not understand.. can u please elaborate

MOHAMMED ABDULLA T

*createmarkpanel nodes 1 'Select a node on the edge' 4

set nodes_aroundhole [hm_getmark nodes 1]

eval *createmark nodes 1 $nodes_aroundhole

*createstringarray 4 'Remesh: 1' 'AdjacentComp: 2' 'CurvedFill: 1' 'DefineMaxWidth:0'

*fill_fe_holes 1 1 0 1 4

Altair Forum User

Hi Nguyen Dai,

 

Where is the interactive mode? Can yoou please guide me..

Altair Forum User

Hi Mohammed,

 

I have tried the code. We are using hm14 version where fill holes option has not introduced yet. Is there any other way you can help me with please?

Q.Nguyen-Dai

Altair Forum User said:

Hi Nguyen Dai,

 

Where is the interactive mode? Can yoou please guide me..

 

Aiiiie, /emoticons/default_tongue.png' srcset='/emoticons/tongue@2x.png 2x' title=':P' width='20' />

MOHAMMED ABDULLA T

Hi Mahit,

*fill_fe_holes command supports from 13 onward. Only you have to do is make little changes on *createstringarray command and try to run.

 

<?xml version="1.0" encoding="UTF-8"?>