buckling exclude of an area in Optistruct optimization

Altair Forum User
Altair Forum User
Altair Employee
edited November 2020 in Community Q&A

Dear support team,

I tryed to start an optimization with two Load steps. The first is a general static load step and the second is a buckling loads as subcase which I need for my buckling response. 

The problem is that I want to Exclude the area of the rib in the buckling Analysis, but it can't find the Panel-Set. Where is the failure ?

 

 

Unable to find an attachment - read this blog

Tagged:

Answers

  • Rahul Rajan_21763
    Rahul Rajan_21763 New Altair Community Member
    edited May 2016

    Did you try for EXCLUDE card?Please find attached screenshot for same.

    <?xml version="1.0" encoding="UTF-8"?>EXCLUDE.JPG

Categories