Regarding Problem in Example OS-1085 Linear Steady state Heat Transfer Convection

Altair Forum User
Altair Forum User
Altair Employee
edited October 2020 in Community Q&A

Hello HyperWork User,

 

I have Problem while simulating OS-1085:

 

I don't get such a result which mention in the tutorial, the Red Grid Temperature inside the Pipe:?

 

Second Question is, Can I take more than 2 nodes for convection, that have taken on step 7 as an ID Number.

 

Even I don't find any Ambient SPC tab that mention in step 5 line 10, while preprocessing.

 

Please give me Solution or which step I have missed or I can see in my Input file.

 

Thank you,

 

Regards,

Jay Nayak

<?xml version="1.0" encoding="UTF-8"?>Thermal Convection.PNG

<?xml version="1.0" encoding="UTF-8"?>Thermal Convection_Grid Temp.PNG

Tagged:

Answers

  • Altair Forum User
    Altair Forum User
    Altair Employee
    edited October 2016

    Hi Nayak,

     

    Looks like there is no convection happening. Can you share the complete .out file?

  • Altair Forum User
    Altair Forum User
    Altair Employee
    edited October 2016

    Here, you can see the Output file.

     

    Moreover I want to do Analysis for Heat Transfer. On the Top of my Profile I have Higher Temp. while bottom has lower, and I have to do Conduction Analysis so Temp goes from Higher to Lower.....

     

    How can I apply different Temp. at different Region?

     

    Thank you,

     

    Regards,

    Jay

     

     

    <?xml version="1.0" encoding="UTF-8"?>Thermal_Convection.PNG

    <?xml version="1.0" encoding="UTF-8"?>Thermal_Convection1.PNG

  • Altair Forum User
    Altair Forum User
    Altair Employee
    edited November 2020

    Hi,

     

    Can you run the attached file at your end and check if you get the same result?

    Unable to find an attachment - read this blog

Categories