Errors in CMA solver

User: "Altair Forum User"
Altair Employee
Updated by Altair Forum User

Dear experts,

I met thses problems that I was unable to slove.

When I created a UWB antenna model without CMA, it shows NOTICE about 'checksum mismatch'.Then I added CMA to the model, it shows ERROR about eignsolver.The model can be downloaded in .zip file.

 And I want to know the solution to these and reasons so that I could continue my study in CMA.  Thank u!

 

<?xml version="1.0" encoding="UTF-8"?>TIM截图20190516114140.png

<?xml version="1.0" encoding="UTF-8"?>TIM截图20190516114215.png

<?xml version="1.0" encoding="UTF-8"?>TIM截图20190516114104.png

<?xml version="1.0" encoding="UTF-8"?>TIM截图20190516112410.png

<?xml version="1.0" encoding="UTF-8"?>TIM截图20190516105957.png

Unable to find an attachment - read this blog

Find more posts tagged with

Sort by:
1 - 3 of 31
    User: "Wilco Strydom"
    New Altair Community Member
    Updated by Wilco Strydom

    Hi Lydia.

     

    I see you are a University User, are you able to update your Feko version?

    Your outfile reports

     FEKO.CSV  Version 2018.1-424 from 2018-07-20

    I suspect this error is triggered by the dielectric-metallic junctions shown in your first image. If that is the case then updating should resolve your problems as that error has been fixed.

    Good news is that this error is only triggered in parallel runs, so if you cannot update the solver you could always just perform the run sequentially.

     

     

    User: "Altair Forum User"
    Altair Employee
    OP
    Updated by Altair Forum User

    Thank you for your reply.

    There is still some problems after I use education edition instead.I requested  currents and checked the result so that I could add CMA for the next step, but it showed as followings:

      

    <?xml version="1.0" encoding="UTF-8"?>TIM截图20190603143830.png

    User: "Torben Voigt"
    Altair Employee
    Updated by Torben Voigt

    Hi @Lydia He, these are just comments (not warnings). They say that you can increase the speed of your simulations by activating parallel computation and also that the former *.str file has been re-written. FEKO stores the currents in *.str files so that they can be re-used in later simulations of the same model, if e.g. different requests are made.

    image.png.c24502627dbf028f2eb3ef25c07179b6.png