Error ID 213 In Out file of radioss solver

Altair Forum User
Altair Forum User
Altair Employee
edited October 2020 in Community Q&A

i am new to the hyperworks, Can someone please help me resolve the following errors

After running the starter file i get below error:-

 1. Job load: 1
Restart file drop test_0000_0001.rst was not created.
Missing 'NORMAL TERMINATION' in output file drop test_0000.out.
'ERROR TERMINATION' in output file drop test_0000.out.

2. Also at end of the out file following error is there:-

Error ID 213: INPUT ERROR IN MATERIAL LAW %d

 

Tagged:

Answers

  • Altair Forum User
    Altair Forum User
    Altair Employee
    edited February 2019

    I have found cause of the error, actually i was not defining the a, b, n of LAW2 Material Properly.

    Can someone tell me these values for Aluminium and ABS.

    Thanks in advance.

  • Pranav Hari
    Pranav Hari Altair Community Member
    edited February 2019

    Hi mgodara880

     

    If you are using MAT law 2, you can use the option iflag -1 and run the simulation. You will get the value of  strain hardening exponent (n)and strain hardening parameter(B) as the output of the results.

     

    image.png

Categories