Error in linear analysis - AIF disabled
Altair EmployeeI am trying to perform a linear analysis of a plate with hole, through a video tutorial. I had performer all the required steps as stated in the video, but I am getting an error of 'Error during processing AIF files. AIF disabled.'
I am new to the Hyper Work software, and unable to rectify the error. Please guide me in this. The file which I am using is attached with this message.
<?xml version="1.0" encoding="UTF-8"?>
Find more posts tagged with
Altair EmployeeCan you check the out file is generated or not? If generated please do share same. Your shared file runs fine at my end with same version of student edition.
Dear Rahul Sir
Yes, I do have the '.out' file of the analysed product. I am attaching it with this message.
I have tried many other problems too and every time I am getting this AIF file error. Please help me to correct it.
Regards
Can you try by changing the file location from desktop to any other drive and run again?
Altair EmployeeYes Sir
I just tried doing it and changed the file location. Now its working and I had done analysis of the part. Thanks a lot for your help.
Just to add on to the similar problem, do I have to shift my working directory for all the analysis to any other directory in which Hyper Works software is not installed?
Regards
You can refer pinned topics available in below HyperMesh forum.
Altair EmployeeYou can refer pinned topics available in below HyperMesh forum.
Thanks a lot for the help and advices to resolve my problem.
Regards
Can you check the out file is generated or not? If generated please do share same. Your shared file runs fine at my end with same version of student edition.