Plot stress in the ply direction (Radioss + HyperView 2025)

Romain

Hello,

I created a simple Radioss 2025 model of a composite cube with the P6_SOL_ORTH property. After opening the .h3d, it is impossible to plot the stress in the composite orientation (Ply system) with HyperView 2025 :

I have the following parameters in the 0001.rad file :
/H3D/DT
0.0 0.001
/H3D/ELEM/TENS/STRESS
/H3D/ELEM/ORTHD/LAYER=ALL/IR=ALL/IS=ALL/IT=ALL
/H3D/ELEM/TENS/STRESS/CORNER_DATA

Thank you for your help !

Romain

almeidaaap

Hi, Romain,

Please, make sure to load the model and the result file, also, define the Result math template properly (advanced should work). Here is the link to the help page:

Load Model

I hope this can help.

Regards,

Arthur