The Siemens Community Catalyst program was co-created with our community to acknowledge technology leaders who consistently contribute to the Siemens Community. Nominations are accepted on a rolling basis.
Hello, I am new to Inspire Cast and am trying to run a flow simulation of this part but I keep getting a negative volume error and do not know how to proceed. I have attached the solidworks part and the cast file. Any ideas about what to try?
Hello @jtrhoad ,
I looked at the .icast file you shared. Although it works on my end without an issue, there could be three potential reasons for mesh failure here causing negative volume.
Join us for a Community Conversation where we'll discuss practical approaches to analyzing complex electromagnetic models using hybrid solver techniques. This session will provide a general overview of how different computational methods can be combined within a single simulation to address models containing varied…
Join us for a community conversation to explore how different modeling approaches in Simcenter PSIM can help engineers simulate power electronics systems while balancing accuracy, simulation speed, and design insight. What you'll learn: Power transistor modeling : Thermal and high fidelity models Protection component…