SimLab Flux Motion Issue

Tom25_RP

I currently am having an issue with using SimLab Flux solver. I have attached the error log text file that I received. I cannot provide the model due to IP however I am trying to model a permanent magnet coupling in order to find torque and loss. I have added a motion to the outer part with values shown below. In the error log it says that the AngPos value is not a number. Any thoughts on what could be causing this? Any thoughts greatly appreciated thanks.

SimLab Error Log.txt

Charishma_Modem

Hello,

Thanks for reaching out.
I have just checked the solver log file and I believe the error is not related to the motion.
'AngPos value is not a number' is a warning message. That being said, the reason for the error cannot be figured out just by looking at the Slover log file. I totally respect your concerns on IP and would request you to take a chance of creating support request or writing to hwsupport@altair.com. Once the support ticket is created, our team will look at the request. If needed we can have scheduled meeting or you can upload your model in the ticket created privately.

Note: Please don't share any model here in community, as its a public website and can be accessible to all.

Hope this is helpful!

Best Regards,
Charishma Modem