FluxMotor to Flux Magnet Loss by Joule effect

Hallay

Hello Expert

I have a question about magnet loss by Joule effect.

Use FluxMotor 2023.1 to export motor model to Flux 2D (2023.1).

When I choose Full model to export, I get magnet loss by Joule effect around 42W.

However, choose Not Full model to export, also get 42w in magnet loss by Joule effect.

This is 1/6 model, magnet loss Joule should be 1/6 or Flux will give me whole magnet loss?

thank you

asoualmi

Hello,

Could you please check if the calculation is performed on the model shown or on the circuit? If it's performed on the circuit, the result will be the total. But if it's performed only on the portion shown in the main circuit, you must multiply by the period to obtain the total. To verify, simply edit the sensors.

Thank you.