Hello Every one

Qasim Azze

Hi, all friends.

I have a question about getting cogging torque.

I did both 2D and 3D for the same motor. However, I get different results. from 2D and 3D, about 0.17 in degrees?

How to solve this problem?

Thanks in advance.

I have followed the steps of YouTube.

https://youtu.be/Fz3DMyuAwgQ?si=sRcIXgLc0s_iRA36

https://youtu.be/QnrrgplGCzc?si=RIsQdhj5Fp_IUjyu

Find more posts tagged with

Flux

Auto Tagged

Accepted answers

All comments

Charishma_Modem

Hello Qasim,
Thanks for reaching us. The difference can be due to several factors. It will be difficult for us to comment about difference in the results without actually looking at the models. I recommend opening a new support ticket and attach your 2D and 3D models in the ticket for us to take a look. Please don't share the models in community as it can be viewed publicly.

Thank you,
Charishma.

Qasim Azze

Thank you very much. I will do this.

Qasim Azze

I have sent you an email that have the 2D and 3D

Qasim Azze

2D+3D.jpg

2D and 3D of the same model for cogging torque ?

Thanks.

Charishma_Modem

Hello Qasim,
can you put an email to hwsupport@altair.com. Our team will open a support ticket on your behalf.
Thank you,
charishma

Qasim Azze

Thank you I have send an email to the

hwsupport@Altair .com

best regards